&There Are Specific Types Of Baskets, Such As Electric Baskets, Construction Baskets, And Aerial Work Baskets. And The Following, Will Involve The Specific Kind, Is For The High-altitude Work Basket This Kind Of Basket, Because It Is The Website Product And The Key Word, Therefore, Will Carry On This Work, In Order To Let Everybody Have The Study Content, Then, Can Come To The Correct Use And The Reasonable Use, But Not The Wrong Use.   &1. What Are The Specific Requirements Of The Basket For Aerial Work On The Hoist? &The Specific Requirements For The Hoister Are As Follows:   &The Locked Rotor Torque Of The Motor Shall Not Be Less Than 180% Of The Rated Torque, And It Shall Have Good Rope Threading Performance Without Rope Jamming And Other Problems. &If There Is Any Exposed Part In The Rotating Part Of The Hoist, There Should Be Corresponding Hood Or Protective Device To Protect It. &Nbsp; & Nbsp; (3) On The Transmission System, The Clutch And Friction Transmission Shall Be Prohibited Before The Rope Sheave. In Addition, The Ratio Of Rope Wheel Diameter To Wire Rope Diameter Shall Not Be Less Than 20. In Addition, When Carrying Out Static Test Load, The Sliding Distance Shall Not Be More Than 10 Mm After The Brake Works For 15 Minutes.   &Can The Basket Be Lengthened? Is There Any Requirement For The Bearing Strength At The Top Of The Building? &The High-altitude Work Basket Can Be Lengthened, But It Can Only Be Lengthened Properly, Because If It Is Too Long, It Is Not Convenient To Use, And It Will Bring Some Danger. However, The Bearing Strength Of This Kind Of Hanging Basket At The Supporting And Hanging Place On The Top Of The Building Is Required By Regulations. Generally Speaking, It Can Not Be Less Than 1500kg / M3.   &What Are The Overhaul Cycle And Contents Of The Basket For Aerial Work? &Generally, The Work Basket For High-altitude Work Shall Be Overhauled Every Two Months, And The Basket Shall Be Comprehensively Inspected. In Terms Of Maintenance Content, It Is To See Whether There Is Wear At The Friction Point, Whether There Is Damage At Each Contact Point, And Whether The Safety Device Can Be Used Normally. If There Is Any Problem, It Shall Be Solved In Time Without Delay.